MIL-PRF-83817B
proportionally controlled transmission allowing the entire vehicle to creep forward or backward
as needed to set or remove a C-130 engine.
3.3.9.18.2 Pintle hook attachment. When specified (see 6.2), the forklift will be shipped with a
pintle hook attachment. The pintle hook attachment shall provide all of the capabilities as
described in paragraph 3.3.9.15 and its subparagraphs. If the pintle hook attachment is offered,
then a separate fork tine attachment is not necessary.
3.3.9.18.3 Other attachments. Any attachments developed commercially or otherwise which are
approved for use by the contractor for this forklift shall be available for purchase by the users.
3.3.9.18.4 Manual supplements. The necessary load charts and guidance supplements shall be
provided with all attachments. Use of the attachments as prescribed in the supplements shall be
covered under the manufacturer s original vehicle warranty. The use of a newly obtained
attachment, which is approved by the manufacturer, for a previously fielded forklift shall not
void the manufacturer s warranty.
3.4 Environmental conditions.
3.4.1 Operating temperature range. The forklift shall be capable of operating in ambient
temperatures ranging from -25° F to +125° F. When specified (see 6.2), the forklift shall be
furnished with type A winterization and shall be capable of operating in ambient temperatures
ranging from -40° F to +125° F.
3.4.2 Storage temperature range. The forklift shall be capable of being stored in ambient
temperatures ranging from -25° F to +125° F. When specified (see 6.2), the forklift shall be
furnished with type A winterization and shall be capable of being stored in ambient temperatures
ranging from -65° F to +140° F.
3.4.3 Winterization. (Minimum Requirements)
3.4.3.1 Type C winterization. The forklift, at a minimum, shall be furnished with Type C
winterization that shall protect to -25° F. The forklift shall start within 5 minutes using only the
engine or other component preheating designated below, and it shall be fully operable within 15
minutes. The forklift with Type C winterization shall consist of the following:
3.4.3.1.1 Starting aid. Glow plug(s) or a measure shot ether injection system shall be furnished.
3.4.3.1.2 Cab. The cab shall meet the requirements of (see 3.3.9.9), and shall also contain
thermal insulation, if necessary, to meet the heating requirements of (see 3.4.3.1.3).
3.4.3.1.3 Cab heater and defroster. The heater shall have sufficient capacity to maintain a
temperature of at least +40° F at cab floor level in an ambient temperature of -25° F.
3.4.3.1.4 Anti-freeze engine. To protect the engine from freezing, the coolant system shall be
protected to -25° F with antifreeze.
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business