MIL-T-52698A
The identifying data to be applied to the identification plates shall be as indicated herein and as defined in MIL-STD-130. Identification data shall include National Stock Number (if applicable), contract number, serial number, and US Military Property Number. The truck shall also be equipped with instructions, warning, and caution plates conforming to MIL-P-514, type III, composition C, of type 1, grade A, class 1 material, prominently located and describing any special or important procedure to be followed in operating, loading, and servicing of the truck or its components. All plates shall be securely attached to the truck with screws, bolts, or rivets, and shall be furnished and mounted by the contractor.
3.14.1 Instruction plates. Each truck shall be equipped with instruction plates or diagrams, including warnings and cautions, describing any special or important procedures to be followed in loading, operating, or servicing the truck. Instruction plates shall conform to MIL-P-514, type III, composition C, of type I, grade A, class 1 material. Plates shall be attached by screws, bolts, or rivets in a conspicuous protected location.
3.15 Workmanship. All workmanship on the truck shall be in accordance with the engineering and production standards of the materials handling industry. The truck shall withstand any operation specified herein without permanent deformation, breakage of connections, malfunction, or component interference caused by incorrect workmanship. All parts of the truck before and after painting shall be clean and free from sand, rust, dirt, fins, pits, sprues, scale, flux, and other harmful extraneous material. Edges and surfaces exposed to operating and maintenance personnel shall be smooth and rounded to the extent that a hazardous surface does not exist. Pivot points shall have hardened pins and bushed holes.
3.15.1 Bolted connections. Boltholes may be subpunched or drilled undersize prior to welding and reamed to full size after all welding has been completed, or drilled to full size after all welding has been completed. All holes shall be drilled or reamed through steel templates. Boltholes shall be drilled or reamed straight through from one side of the component.
3.15.2 Welders and welding.
3.15.2.1 Welders. Before assigning any welder to manual welding work covered by this specification, the contractor shall obtain certification that the welder has passed qualification tests as prescribed by either of the following listed codes for the type of welding operations to be performed and that such qualification is effective as defined by the particular code:
ANSI/ASME Boiler and Pressure Vessel Code, Section IX, Welding
Qualifications.
ANSI/AWS B2.1, Welding Procedure and Performance Qualification.
Certification shall be made available for review by the contracting officer or designated representative upon request. Contractors who make only horizontal welds need not qualify welders for "all position welding". Subject to
approval by the Government, the contractor's standard welder qualification may be substituted in lieu of the above codes provided that the contractor's procedure is equivalent to the above codes. The contractor shall be
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business