MIL-T-52953C
3.25 Treatment and paint. The parts of the truck normally painted shall be cleaned, treated, and painted in accordance with the contractor's commercial practice. Unless otherwise specified (see 6.2) final color shall be contractor's normal color. The cowl overhead guard and mast may be matt black in color. When specified (see 6.2), the final color shall be in accordance with color 13538 of FED-STD-595 and treated and painted in accordance with MIL-T-704, type A (also see 3.3.4.5, color in special purpose vehicles and equipment and footnote 1 to table 1I in MIL-T-704). When
specified (see 6.2), coating aliphatic, polyurethane, chemical agent resistant (CARC) MIL-C-46168 shall be used. However CARC shall not be applied to surfaces which exceed 400 °F. An alternate high temperature paint, in the appropriate color shall be used. When CARC is specified, the identification plate (see 3.27) shall state "Painted with CARC". The vehicle shall be rustproofed as per the instructions provided in MIL-R-46164 and MIL-C-62218.
3.25.1 Walkway coating. Floor plates and step surfaces shall have skid resistant surfaces conforming to MIL-W-5044 and MIL-W-5050.
3.26 Identification marking. Each truck shall be identified with an identification plate conforming to MIL-P-514, type I, style 1, composition C, of type I, grade A, class 1 material which shall be located in a visible and permanent location on the truck. The identifying data shall be stamped in letters in accordance with MIL-P-514. The plate shall be securely attached to the truck with screws, bolts, rivets, or by welding and shall be furnished and mounted by the contractor.
3.26.1 Truck marking. Marking on trucks shall be painted black or other designated color, using the designated military paint specified in 3.25. Characters shall be block type capitals, and Arabic numerals. Location and character size shall be as follows:
Information |
Example |
Location |
Minimum character size (Ht.) |
Agency Registration number Capacity Safety Tire pressure Lifting/tiedown points |
US 10D315 6000lb. Cap No smoking No riders 80 psi Lift/tiedown |
On each side and rear On each side and rear On each side On rear of mast On rear of mast On truck above each wheel Near lift/tiedown points |
1.5 inches 1.5 inches 2 inches 1 inch 1 inch 1 inch 1 inch |
3.27 High altitude electromagnetic pules (EMP). When specified (see 6.2), schematic and electrical diagrams detailed to the component level (i.e., resistors, capacitors, filters, transistors, SCRs) with value of all components of the forklift shall be furnished by the contractor to the Government to assist the Government in performing the EMP evaluation. When specified (see 6.2), a forklift shall be furnished to the Government and shall be evaluated by the Government to determine necessary protection devices for protection against EMP.
14
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business