MIL-T-52864D
shall be equipped with a minimum of two fully opening or removable doors. Each door shall have a safety latch, opening stop and hold-open catch. All hardware shall be of the heavy-duty or industrial type, resistant to corrosion. The cab shall be equipped with not less than two ventilation fans
not less than 6 inches in diameter. Fans shall be directionally adjustable to direct airflow toward all glazing. Fan(s) shall have "on-off" switch(es) which are labeled "ON" and "OFF" and are within the seated functional reach of the 5th percentile female operator. The cab shall be removeable and independent from the overhead guard specified herein.
3.22.1 Glazing. The cab shall provide the operator with all around visibility. The total glazed area shall be not less than 4000 square inches
of tinted windows consisting of windshield, sliding or roll-down door windows, rear window, roof window, and other windows as determined by cab design. All glazing shall conform to ANSI Z26.1, type AS1 in the windshield and roof
window and type AS1 or AS2 in other windows. In lieu of type AS1 glazing for the roof window, shock resistant clear plastic treated to prevent scratches
due to window wiper operation and which shall not become opaque throughout the life of the truck can be used. Fixed glazing shall be sealed in waterproof stress-absorbent molding, and movable windows shall be sealed on extra heavy type, pile lined channels, or heavy duty self-draining plastic channels.
3.22.2 Interior. The interior of the cab shall be fitted with insulation, retarding both heat loss and noise intrusion. The insulation and framing shall be covered with an interior skin and headliner, providing a smooth, cleanable protective cover.
3.22.3 Windshield and window wipers. The cab shall be equipped with at least three electrically powered-wiper assemblies to clear the windshield, the rear window and the roof window in accordance with the performance
requirements of SAE J198. Self-parking features shall be provided. Wiper arms and blades shall be of the commercial heavy-duty type having saddle and pin blade fastenings. The wiper arms shall provide tension on the glazed surface of at least 1 ounce for each inch of wiper arm length. The operator controls shall be installed on or adjacent to the instrument panel.
3.22.4 Heater. A recirculating-air type heater shall be furnished. The heater shall have a rating of at least 18,000 Btu/hour. The heater controls shall be near the operator and shall provide for variable selection of blower speeds.
3.23 Lubrication fittings. Lubrication fittings shall conform to SM J534. Fittings shall be located in a protected accessible position. Fittings shall be accessible by all grease guns conforming to MIL-G-3859, equipped with a hydraulic coupler conforming to MS24207 and a 10-inch flexible extension. Accessibility or fittings shall be provided without the removal or adjustment of accessories or parts. Panels and plates equipped with hand operated fasteners may be removed to provide accessibility. Accessibility shall be in accordance with 3.6.
3.24 Performance.
3.24.1 Lifting speed. Speed of lift with rated load shall be not less
than 55 feet per minute over the entire distance from ground level to maximum lift height.
14
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business